ZX8530 LCR Digital Meter 50hz-100khz 34 points measurable.These series component tester above are the new generation impedance tester in China which use 320*240 Color LCD，it can fit all test requirement of component and material with its 0.05% basic accuracy and 50Hz ～ 100kHz frequency. It can test low ESR capacitor and high Q inductor and also be applied in analyze of the electrical performance in microphone,oscillator, inductor, ceramic capacitor, LCD, variode, transformer.etc.

These series component tester are powerful tools for electrical component design,inspection, QC and manufacture. It can be more suitable for point inspector, curve analyze of frequency response of piezoelectric component .etc in auto production line with its high test speed. Its variable impedance-outputting mode can fit to different standards. With its excellent performance , These series can realize the different tests of commercial and military standards as IEC and MIL.

1.The test data of LCR Digital Meter are highly comparable with those of international brands, including keysight and wk.
2.They haveIt has a 4.3 "LCD screen and a 2U standard chassis;
3.It has a keyboard locking function and a power-off data protection function;
4.It has two languages, namely simplified Chinese and English operating languages; it is easy to operate;
5.Save the test data and test conditions to the U disk or inside;
6.The formats supported by the U disk include FAT1 and FAT32 file systems;
7.List scanning function, open circuit, short circuit and load correction Function;
8.upload data to the computer without installing software;
9.There are 50 groups of test files in the instrument and 500 groups of test files in the USB flash drive, which can be called at any time;
10.Test voltage and current automatic balance adjustment function.

1: plug in the power plug and press the panel switch to on. After starting up, the function of the instrument will be indicated in the last set state. Preheat for 10 minutes. After the balance is reached in the standby state, carry out the normal test

2：For test parameter selection, use the 'parameter' key to select L, C and R, and the unit is as follows: l: Uh, MH and H (secondary parameter: Q value of the device under joint test) C: PF, NF and UF (secondary parameter: Joint Test)D value of device under test) r: 2, KQ, MQ (secondary parameter: Q value between devices under test)

3：he user shall press the frequency key and voltage key according to the test standard or use requirements of the tested part to select the corresponding measurement frequency and test voltage 50Hz, 60Hz, 100Hz, 120Hz，10 frequencies of 1kHz, 10kHz, 20kHz, 40KHz, 50KHz and 100kHz, and three voltages of 1V, 0.3V and 0.1V